Back together. It runs.
Storage building
- Thread starter KTMLew01
- Start date
O'Reilly's has AC gauge set rental with $264 deposit. With a vac pump just short of 500! All fully refundable tho. Think will buy a 75 dollar vac pump as need one to test transmission valve body. I'm tempted to go check with some ex-coworkers and see if can borrow a gauge set and vacuum pump. Right now need to see if it holds vacuum. If it does, "continue to assemble" is the old instructions. The low pressure switch was definitely leaking back couple months ago. It's entirely possible the new Advance Chinese part is leaking too. Let me go see if connector is wet?
Nope. It's dry. Need a black light to look for dye.
Nope. It's dry. Need a black light to look for dye.
Just went to shed to get a funnel. Had to be well over 100 degrees. Have a box fan running but really need to increase the vent size & move the fan. Opened everything up to let air flow. Made huge difference in less than 5 minutes. Kinda like to put in couple windows.
8AM tomorrow start eye treatments.
Still somewhat dilated so will be quick. They found also had a small retinal tear. Doc asked if wanted to go ahead and have her weld it while was already numbed up. Sure! Today's the day. Then after allowing the weld (laser) to cool down for 20 or so minutes, mainly waiting to see if I spontaneously combusted I think, into the torture chamber for two needles in the eye. Crazy chit.
I DID, unofficially, get the good drugs. Because I saw the pool/bubble of stuff going in and floating around. The "sham treatment" would just be some pressure on the eye. I could definitely feel the needle and see the drug. Noice! Go back next Wed to make sure everything looks fine. Then 20th of next month and every 20th'ish for next 5 months.
Eye was pretty pizzed-off on way home. Not sure if the Betadine was the cause, the vise-grips on the eyelids or the torching but it was a bit sore. The torching definitely almost immediately helped left peripheral vision.
I DID, unofficially, get the good drugs. Because I saw the pool/bubble of stuff going in and floating around. The "sham treatment" would just be some pressure on the eye. I could definitely feel the needle and see the drug. Noice! Go back next Wed to make sure everything looks fine. Then 20th of next month and every 20th'ish for next 5 months.
Eye was pretty pizzed-off on way home. Not sure if the Betadine was the cause, the vise-grips on the eyelids or the torching but it was a bit sore. The torching definitely almost immediately helped left peripheral vision.
Top is right and normal think ness. The other picture. Supposed all be green. All swollen up!
^^^few spelling arrows but ewe'll figure it out.
Post 1727. The target thickness is around 250 microns. Bad part of mine is little over 600!
Post 1727. The target thickness is around 250 microns. Bad part of mine is little over 600!
Eye was pain free when got up at 5:30AM. Went to bed too early so there you go. By noon eyelid/eye was pretty sore. Seems like light sensitivity. Went to bed and slept'ish for about 3 hours. Don't feel 100%. I'm moving around like an infant. Lean forward at all and feel like i'll tip over. Not dizzy. Zero appetite. The shot has had no effect on the distortion but considering it's a six shot protocol don't expect much for at least 3 months. The laser work did fix the peripheral tho.
Feel better today. Eye is pretty good just seems like it's completely quit making natural tears. Have to give it a squirt of Systane hourly. Still can't see chit. Be few months at best for it to improve.