I think with he leaving HMS and jarrett leaving MWR, i'm wondering if germain racing might be looking at a 2 car cup team, or if red bull and bill davis want to go to 3 teams?
how about Penske to race with his brother?
So Truex Jr., Shrub, Menard and Biffle. That's not a bad lineup and with the proper support they could make some noise.
IMO, bad idea. Penske is spending truckloads of money just to repair Kurt's cars. He don't need shrub wrecking even more. It could bankrupt him...
yeah, with mikey.Has anybody considered Toyota? Kyle would be a good catch for them.
This is just my prediction.
Kyle Busch will race with RCR, car no. 51.
Ryan Newman will leave Penske and join DEI.
Hornish will go to Cup fill-time.
read my initial post in this topic...Has anybody considered Toyota? Kyle would be a good catch for them.
Rowdy with RCR? It could happan.
Tuesday when they started reporting this on ESPN, me and dad was at The Keg in Murray, and it said that JR will replace Kyle Busch. Well dad askes "Who was that dumbass that left last year, he can't even make a race" So that may not be a smart move by Rowdy to leave.
Could he go back to Roush?
Both me and dad knew it was Vickers. But he is basicly a nobody this year. Vickers leaving HMS was pretty stupid.
Toyota will figure it out and be the top car. Why was it stupid for Vickers to leave? He was being outcast at hms, just like Kyle is now.
Kyle was looking elsewhere BEFORE Junior, mainly because he feels his ego wasn't being stroked enough. JMO
Toyota will figure it out and be the top car. Why was it stupid for Vickers to leave? He was being outcast at hms, just like Kyle is now.
Vickers leaving HMS was pretty stupid.
Both me and dad knew it was Vickers. But he is basicly a nobody this year. Vickers leaving HMS was pretty stupid.
Brian didn't leave, he was fired for wrecking too many cars. Even when he finaly won a race it was at the expense of his teammate & more bent sheetmetal.
=Restrictor Plate King!] when he finaly won a race it was at the expense of his teammate & more bent sheetmetal.
Is that just your opinion, or do you have a link to a story that backs that stement up?