KTMLew01's latest activity

Just occurred to me, could just line them up, remove the wheels from the bench. Think be really close on height. Close enough to slip...

In picture nearly 1/2" lower than bench. If anything rather have saw slightly proud. I'm only good for maybe 4 hours of doing stuff...

Two 2x4 stacked (1.5 + 1.5) with piece of 1/2" plywood over gets saw up to where the shed bench will work for in-feed. I'm more worried...

This is what I'm talking about. He's a bit of a show pony but that's what he's getting paid for. Be no sanding plywood in my shop! Manly...

The judicial system is only valid when it leads to outcomes that I personally agree with. When it doesn't, there is clearly always an...

Trying to use participation in SRX, a spec car series that was basically a part time gig for retired drivers and Hailie Deegan, as proof...

Was trying to figure out a way to use saw on the trailer. Need to rip edge of 12 foot 2x6. OK...you have infeed & outfeed. Table entry...

I'll start posting every hour.

Still has the spotted pony look. I COULD paint some of it any time I get the urge. Just haven't had that urge yet. I'd like to replace...

Left tail light works but signal doesn't. I'll find my crimp connectors and cut the turn signal wire and test as don't think can remove...

We have a table saw. 100 bucks 7 minutes from home.

Not looking good. Checked on the one and got the "oh I'm sorry...something came up tonight". And nothing more. No "we could do it...

Trailer is ready to roll except right taillight seems to have quit. Or a wire is broke. I don't care. LED lights I put on and replaced...

Ordered new bolt which comes in pack of two. 8ish bucks. Going to clean off the trailer and get it ready. Certain can do it that way so...