KTMLew01

Finally did some angle braces too. Helped some.

Got two truss set and one up ready to be set. Dizzy as ****. Not in a funny way. Guess rest will get 4" screws toe-nail style.

Have 12 foot 2x4's on top plate of 10 foot stricture. Standing under 2 foot sticking out, on a stool, marking where to cut them. 12ish...

So...Hardee's Chicken biscuit & coffee: CHECK! Came home and turned power on to shed/kick-started air compressor: CHECK! Sitting in...

Went back out and hung another concussion maker (2x8 for scaffolding) and trimmed the siding. Set plates up but didn't nail. Cleaned...

If my lower backs? WTF was that?🤣 Think was going for lower back pops...I was upside down ish. Leave me alone...

Put myself in the rack. If my lower backs while hanging in this thing I'll probably pass out

Third picture shows where I used 3/4 OSB in between the plates. Oddly enough, other side came out perfectly. This is why you don't start...

I'm done for today. Back has decreed that, if I continue any further today, it will kill me at 2:36 AM. No exceptions. Need to trim inch...

This is good excuse to quit working on the shed till later when sun goes behind the trees.

Freaking edit time limit sucks... Need to trim siding at front gable so top plate fits then start tossing truss on this beotch. Gonna...

Is that 4 layers of shingles? No wonder it was sagging in the middle.

Let's see if can attach. Nope. This video is too large...but the roof is off! Drug it off with long ratchet strap and my truck. We're...

Dribbling now. I can hear the drip, drip, drip of gonorrhea...wait? I mean RAIN on the window A/C. I should make an awning of sorts for...